Hey pals. I have one of those semi-auto vz 61 Skorpions (.32 Auto or 7.65mm Browning). I'm planning on using it as the basis for a Form 1 project (more on that in another thread). Anywho, I'd like to thread it for use with a can. However, the barrel, as far as I can tell, is too thin as is. I reckon it will have to be threaded and an adapter installed.
Query: Can anyone recommend a service that could do this? The companies that I've contacted either didn't reply or couldn't. I know it can be done as I've seen them wearing suppressors and at one point CzechPoint USA sold some threaded at the factory. Mine is one of the earlier D-Technick marked pistols, so it is not threaded.
Thanks for any assistance.
Query: Can anyone recommend a service that could do this? The companies that I've contacted either didn't reply or couldn't. I know it can be done as I've seen them wearing suppressors and at one point CzechPoint USA sold some threaded at the factory. Mine is one of the earlier D-Technick marked pistols, so it is not threaded.
Thanks for any assistance.
