anybody on here good at adjusting the head spacing on a 10/22 bolt or manipulating the barrel set back into the receiver?
I'm having an issue with my bolt picking up the round and chambering it properly. it hits and stops, and if I pull back on the charging handle about 1/4" and let it go, it'll chamber fine... but then it messes up the next round, and every following round...
ideas, thoughts, insight?
This is on an older receiver that I put a cut down threaded barrel on to make into a custom AR style pistol with a Nordic Components kit and a KAK blade buffer and brace...
I'm having an issue with my bolt picking up the round and chambering it properly. it hits and stops, and if I pull back on the charging handle about 1/4" and let it go, it'll chamber fine... but then it messes up the next round, and every following round...
ideas, thoughts, insight?
This is on an older receiver that I put a cut down threaded barrel on to make into a custom AR style pistol with a Nordic Components kit and a KAK blade buffer and brace...