Hawk's M14 Dummy Kits
- Thread starter gunshow
- Start date
The Best online firearms community in Louisiana.
Member Benefits:
Fewer Ads! Discuss all aspects of firearm ownership Discuss anti-gun legislation Buy, sell, and trade in the classified section Chat with Local gun shops, ranges, trainers & other businesses Discover free outdoor shooting areas View up to date on firearm-related events Share photos & video with other members ...and so much more!
Member Benefits:
I've purchased several of his button kits (without the selector arm), have installed on standard, oversize, and fiberglass stocks. No problems, easy to install. All you need is a drill, a couple of bits, and a screwdriver (see the instructions on Hawk's site). My kits came with chromed screws but I didn't like them, even though the chrome doesn't show from the outside. I replaced them with black screws from the hardware store. Current kits might come with black screws.
If you are looking for a connector arm, make sure it'll fit on your receiver. Certain receivers like the Armscorp have a rail that's too wide, again read the instructions. And, I don't think that kits with the Switch will work with an oversize stock.
If you are looking for a connector arm, make sure it'll fit on your receiver. Certain receivers like the Armscorp have a rail that's too wide, again read the instructions. And, I don't think that kits with the Switch will work with an oversize stock.
Last edited:
Members online
- BDill
- jht1980
- Jafarticus.
- Evil Zim
- 70mikenike70
- JBP55
- Steve-0
- Scrape
- jeremyschudmak
- miscverb
- black-irishman
- Target Sports USA
- drill sgt
- Markrobichaux
- dat722
- tallguy606
- DBMJR1
- theway109
- ffgillst2
- RepJackMason
- twinin
- Rodog
- Big H
- kz45
- TWaggenspack
- sksshooter
- EM696
- 103M 95G
- sawgrass
- pangris1
- jcomar1
- dontshootmebrah
- Mac204
- Mr_dees
- do2gomike
- chips
- Gmac
- PECEMKR
- Gatordude
- Easyt
- CavalryJim
- Speedtrucker
- T-boy
- JNorth24
- Ranslem9849
- SGT ROCK
- Seth35
- cbablair
- GunRelated
- rm2092
