Join BayouShooter For Free
Meplat

Page 2 of 2 FirstFirst 12
Results 11 to 19 of 19
  1. #11
    Redneck with a gun!

    User Info Menu

    It's all done and a fresh coat of paint.


    goodwill collegeville
    _________________
    "Life is tough ..... It's even tougher if you're stupid." John Wayne

  2. #12
    Marksman

    User Info Menu

    Very nice.
    All things are common in slAKerville. USPSA# 66506

  3. #13
    Marksman

    User Info Menu

    Very cool. Well done for sure.

  4. #14
    Redneck with a gun!

    User Info Menu

    I can only take credit for the stock install. Someone else did the paint. He did a great job.
    _________________
    "Life is tough ..... It's even tougher if you're stupid." John Wayne

  5. #15
    Marksman

    User Info Menu

    How much did it cost you for the parts? I’ve been looking to do this for a while now
    Someday I want to say with an unflinching "Yes, I can shoot somebody."
    - Cat

  6. #16
    Marksman

    User Info Menu

    Looks good. Turned out well.
    SASS #84934

  7. #17
    Redneck with a gun!

    User Info Menu

    Last edited by AK shooter; September 11th, 2020 at 06:36 AM.
    _________________
    "Life is tough ..... It's even tougher if you're stupid." John Wayne

  8. #18
    Marksman

    User Info Menu

    Iíve got a 223 Iím wanting to convert to side folder/weld up, holes drilled to pin the FS/G blocks and have a definitive arms mag well installed only place Iíve found willing to do the work is in Prairieville ($$$$) if you know what I mean. So Im thinking Iíll do everything and just pay them the 450 to install the magwell. I built a few over the years just a little worried about cutting and welding on the receiver my self. Having the tools (press/welder/drillpress/ect.) what did you use to mark the holes and what difficulty level would you put this at? 1-10


    Sent from my iPhone using Tapatalk

  9. #19
    Redneck with a gun!

    User Info Menu

    I have some reciever stubs that I used to mark the left side where the pin sits. Once that was cut the holes for the forward and top rivet are the same. Just have to make cuts for the latch.
    _________________
    "Life is tough ..... It's even tougher if you're stupid." John Wayne

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •