10.5" AR Complete Upper Receiver
No Bolt Carrier Group Included
Last photo shows ding on handguard from use. Everything else is in good shape.
Barrel is new/unfired , I have photos of when I replaced it. The barrel is dimpled in one place.
I checked headspace with a good SIONICS bolt prior to installation, it passed.
Gas block installed with knurled cup point screws and Loctite 271 torqued to 25 in/lbs.
Muzzle device was installed with Surefire shims at 25 ft/lbs without Rocksett.
I can remove the Keymo flash hider and install an A2 birdcage at a lesser cost.
Location: Covington Area
Asking $475 FTF Only
PM me if you want more photos or have any questions.
DO NOT PM ME WITH A PHONE NUMBER
No Bolt Carrier Group Included
- Aero Precision Assembled Upper Receiver
- Rosco Mfg Bloodline 10.5" 556 Barrel / Carbine Length Gas
- Bravo Company Mfg MCMR 10" Handguard
- Forward Controls Design GBF Low Profile Gas Block
- SIONICS Melonite Carbine Length Gas Tube
- Dead Air Keymo Flash Hider (installed with Surefire shims)
- USGI Charging Handle (don't remember the brand)
Last photo shows ding on handguard from use. Everything else is in good shape.
Barrel is new/unfired , I have photos of when I replaced it. The barrel is dimpled in one place.
I checked headspace with a good SIONICS bolt prior to installation, it passed.
Gas block installed with knurled cup point screws and Loctite 271 torqued to 25 in/lbs.
Muzzle device was installed with Surefire shims at 25 ft/lbs without Rocksett.
I can remove the Keymo flash hider and install an A2 birdcage at a lesser cost.
Location: Covington Area
Asking $475 FTF Only
PM me if you want more photos or have any questions.
DO NOT PM ME WITH A PHONE NUMBER
Last edited:
