From the ATF:
"The ATF procedure for measuring barrel length is to measure from the closed bolt (or breech-face) to
the furthermost end of the barrel or permanently attached muzzle device. Permanent methods of
attachment include full-fusion gas or electric steel-seam welding, high-temperature (1100°F) silver
soldering, or blind pinning with the pin head welded over. Barrels are measured by inserting a dowel rod
into the barrel until the rod stops against the bolt or breech-face. The rod is then marked at the
furthermost end of the barrel or permanently attached muzzle device, withdrawn from the barrel, and
measured."
The ATF says "permanent methods...include" rather than "permanent methods...are." Has the ATF provided any other examples of acceptable or unacceptable methods? I'm specifically wondering about rocksett.
"The ATF procedure for measuring barrel length is to measure from the closed bolt (or breech-face) to
the furthermost end of the barrel or permanently attached muzzle device. Permanent methods of
attachment include full-fusion gas or electric steel-seam welding, high-temperature (1100°F) silver
soldering, or blind pinning with the pin head welded over. Barrels are measured by inserting a dowel rod
into the barrel until the rod stops against the bolt or breech-face. The rod is then marked at the
furthermost end of the barrel or permanently attached muzzle device, withdrawn from the barrel, and
measured."
The ATF says "permanent methods...include" rather than "permanent methods...are." Has the ATF provided any other examples of acceptable or unacceptable methods? I'm specifically wondering about rocksett.