Negative on the ammo. Went looking for some .38 special and discovered all the AR's. Looks as is if things might be getting back to "somewhat normal"...good to see.
Well, if Cooper plays the role of Chris Kyle i would hope he bulks up for the movie.
But I do agree with a previous poster "Chris Hemsworth" would be a great Chris Kyle.
No doubt in my mind. But I'm 100% positive that if my PX4 could past my rigorious test. LOL. Thats sitting nice and comfortable between my center console and drivers seat. I feel 100% safe with it. If i do want to put any of my guns through rigorious testing i'll break out my Daniel Defense for...
Beretta has a pretty good rep for reliability. Along with a great fit " for me" and i loved the ergonomics of the gun. It just so happens the PX4 fit my every need. The Glock didn't. I know i'm safer with my Px4 than a Glock. Thats JMO.
To each his own. It's what makes the purchaser of that gun most comfortable. What made me choose the Px4 over Sigs, and HK?...Fit. For some reason every gun I held I kept going back to the px4 over and over and over again. I'm not saying its better quality, b/c HK and Sig are top quality, hands...
Thanks for the insight, looks like i'll give it a try and cut a couple on our water jets at work and have one of my customers do the rest of the machine work.
Thanks...so its safe to say i can make me a **** ton of AR-15 lowers as long as i don't sell them correct? And as long as i don't manufacture a NFA firearm? Do i need to place a serial number on each one?
Stupid question but here it goes.....do i need a FFL liscense to do this?
If i do need one, can i cut out a blank profile of a lower, oversize it + .020" and have a machine shop (that has a FFL lisc) finish the profile to spec and do the rest of the machine work?
Thanks