Riceland Guns
Active Member
Selling a custom 6.5 Creedmoor. Details below
- Trued Rem 700 action
- PTG Tactical bolt knob installed
- Nightforce 10 MOA scope base
- Shilen 24" MTU 1:8 twist barrel threated 5/8x24 with thread protector
- Accurate mag DBM and magazine
- Jewel trigger
- Custom fiberglass stock built on an aluminum chassis. Flush cups front and rear
- Action is Devcon bedded into the stock
- Metal cerakoted graphite black
There is a small mark on the receiver I've tried to capture in the picture. Otherwise the gun is in like new condition. Round count is just under 160.
Gun was purchased from a member of LongRangeHuntingforum with 10 rounds on the barrel. Pictured is the first 10 shot group I shot out of the gun with factory Hornady 140g Amax's at 100 yards.
$1750 - scope/rings not included
Remington 700 5R Mil-spec 300WM sold
Thanks
Joel
- Trued Rem 700 action
- PTG Tactical bolt knob installed
- Nightforce 10 MOA scope base
- Shilen 24" MTU 1:8 twist barrel threated 5/8x24 with thread protector
- Accurate mag DBM and magazine
- Jewel trigger
- Custom fiberglass stock built on an aluminum chassis. Flush cups front and rear
- Action is Devcon bedded into the stock
- Metal cerakoted graphite black
There is a small mark on the receiver I've tried to capture in the picture. Otherwise the gun is in like new condition. Round count is just under 160.
Gun was purchased from a member of LongRangeHuntingforum with 10 rounds on the barrel. Pictured is the first 10 shot group I shot out of the gun with factory Hornady 140g Amax's at 100 yards.
$1750 - scope/rings not included
Remington 700 5R Mil-spec 300WM sold
Thanks
Joel
Last edited: