Im again making more room and trying to raise funds for another project. On the block today is an FN Hi Power. I bought this from an ARFCOM member and then sent it off to Kent Singletary to have all the work done. Since returning from Kent I have not fired a round through it. Kent went over it with a fine tooth comb and worked it over to make a fine custom. I do have the work order form from getting the work done if you would like a copy shoot me an email and I will send it. This is what was done.
[ul]
[li]Install C&S wide trigger
Install C&S no bite hammer
Install C&S sear and perform trigger job
Install C&S extended thumb safety
Stipple front strap
Mill and install Novak sights
Install Craig Spegel walnut grips
Polish feedramp
Dehorn
Coat in TAF-1 Black
Recrown barrel
Replace all springs
Test fire[/li]
[/ul]
This gun has over $1000 alone in work and parts no counting the gun itself. Im looking to try to get that out of it. So selling price is $1000 and I will take USPS Money Order. For shipping add another $25. I am located in Baton Rouge and will drive an hour to meet. Also included is a Crossbreed holster and 3 mags. Shoot me an email at cray2751@yahoo.com if interested.
[ul]
[li]Install C&S wide trigger
Install C&S no bite hammer
Install C&S sear and perform trigger job
Install C&S extended thumb safety
Stipple front strap
Mill and install Novak sights
Install Craig Spegel walnut grips
Polish feedramp
Dehorn
Coat in TAF-1 Black
Recrown barrel
Replace all springs
Test fire[/li]
[/ul]
This gun has over $1000 alone in work and parts no counting the gun itself. Im looking to try to get that out of it. So selling price is $1000 and I will take USPS Money Order. For shipping add another $25. I am located in Baton Rouge and will drive an hour to meet. Also included is a Crossbreed holster and 3 mags. Shoot me an email at cray2751@yahoo.com if interested.
