gunsmith near new orleans?

[xd504]

Anyone know a good gunsmith store near new orleans that install sights?
Thanks

 

[Vigilante Sniper]

10-8 Tactical in Elmwood, Maury can help you

 

[NOLASHOOTER]

I second 10-8.

 

[xd504]

Thanks just googled it. "5644 Jefferson Hwy , Jefferson, LA"... Is that the right address?
again thanks. will try that place as soon as i order new sights online.

 

[NOLASHOOTER]

I believe that is right. It is just past Clearview headed west on the river side of Jefferson Hwy. There is a strip mall with a Hilti dealer and an Italian Pie restaurant.

 

[#1bambam]

If they are glock sites you can come by and Ill help YOU put them on for free.

 

[Slim]

If they are glock sites you can come by and Ill help YOU put them on for free.

^ he's a good guy. Put a set on my g26 for me.

Sent from my SPH-D700 using Tapatalk

 

[xd504]

If they are glock sites you can come by and Ill help YOU put them on for free.

No,Their will springfield xd sights. Not sure which one but I'm planning on getting one of these. The stock sites i can't lineup for ****.


http://www.pistolgear.com/proddetail.php?prod=11DPA

or

http://www.pistolgear.com/proddetail.php?prod=XSBD247

 

[SpeedRacer]

Those are two DRASTICALLY different sight sets. Adjustable precision sights vs. huge dot combat sights. What is your intended use for this pistol? Range toy? Home defense/carry?

 

[xd504]

Those are two DRASTICALLY different sight sets. Adjustable precision sights vs. huge dot combat sights. What is your intended use for this pistol? Range toy? Home defense/carry?

Mostly Range shooting. Im a noob to shooting (2 months experience) so i think one of these should be easier then the stock one.

 

[noob]

just an FYI, sometimes it can be VERY difficult to push the factory XD sights.

 

[dmh]

Emphasis on VERY. Most will not move with a pusher. A good vice with proper pads and aluminum punches with the right hammer are usually needed.

 

[SpeedRacer]

Another big +1 to that. Alot of folks have to resort to the BFH, and some XD sights decide to break before budging. I've seen more than one case where they actually had to mill out the front sight.