Well, I pieced together a preferred configuration of my own today from my preexisting rifles and a new Black Rain Ordnance billet upper and lower....long story short: Everything went smoothly until I got to the KNS gen 2 pins that I was moving over from my stag. They're too large! No way was I gonna force them in. I tapped a small amount with a hammer/punch, but no give.
Anyone else run into this problem? Are there a smaller diameter set of pins? The milspec/parts kit pins went in without issue.
PS: It has a RRA 2 stage trigegr in it, not that it should make a difference?
Anyone else run into this problem? Are there a smaller diameter set of pins? The milspec/parts kit pins went in without issue.
PS: It has a RRA 2 stage trigegr in it, not that it should make a difference?