I assembled my 11th build this morning. Went well no issues. Move along to the test firing and this happens;
-Loaded ONE round and fired to make sure bolt locked back and a general "feel". Bolt locked back, sounded good, felt right.
-Loaded TWO rounds. Intended to test cycle... both rounds fired one right after the other.
At this point, being as I was bundled bc I'm a puss to the cold, I tried again thinking I may have managed a bump fire.
-Loaded TWO rounds, made sure rifle was firmly against my shoulder... both rounds fired. Checked trigger and it seems free, doesn't look or feel like it is binding.
-Loaded FIVE rounds. Frist round fired, and no second shot, 2nd round was chambered BUT when I ejected it to inspect, it had been struck so FTFire.
At that point I went home, waiting for a range to open. I have a couple more BCGs and lowers I will try out individually in this build to attempt to find the issue; Ill start by slapping another lower on it and work to the BCG from there. I've never had this issue before, or any for that matter and am at a loss. Anyone who can shed some light on it, or offer a suggestion of anything I should check will get a E-cookie and E-hug from me.
This is the build, BCM BCG, BCM gunfighter CH, BCM barrel, BCM upper, BCM GB, Spikes lower, standard buffer and spring, and a PSA LPK.
Mike
-Loaded ONE round and fired to make sure bolt locked back and a general "feel". Bolt locked back, sounded good, felt right.
-Loaded TWO rounds. Intended to test cycle... both rounds fired one right after the other.
At this point, being as I was bundled bc I'm a puss to the cold, I tried again thinking I may have managed a bump fire.
-Loaded TWO rounds, made sure rifle was firmly against my shoulder... both rounds fired. Checked trigger and it seems free, doesn't look or feel like it is binding.
-Loaded FIVE rounds. Frist round fired, and no second shot, 2nd round was chambered BUT when I ejected it to inspect, it had been struck so FTFire.
At that point I went home, waiting for a range to open. I have a couple more BCGs and lowers I will try out individually in this build to attempt to find the issue; Ill start by slapping another lower on it and work to the BCG from there. I've never had this issue before, or any for that matter and am at a loss. Anyone who can shed some light on it, or offer a suggestion of anything I should check will get a E-cookie and E-hug from me.
This is the build, BCM BCG, BCM gunfighter CH, BCM barrel, BCM upper, BCM GB, Spikes lower, standard buffer and spring, and a PSA LPK.
Mike