I broke an ar tool trying to get the castle nut off.Everyone sAid that if it wasn't a Lmt it would twist right off. Tips ? I wAs using a cheAp American tactical wrench anyone have any ideas? I'm trying to instAll an asap plate btw.
Its a bcm lower it is staked.
The fawking stakes wont back out, even dremeled them out and it still wond budge.
Took the pistol grip off when heating it up incase it was asseumbled with loctite and a million fawking parts fall out.
Euguene stoner sucks.
Kalash FTW.
Well, it is doing what it was designed to do............not come off! I have 0 experience with an asap plate, but do you need the end plate still, or no? if not, you could CAREFULLY score the area between the buffer tube and the indentation on the rear of the reciever plate with a cutting wheel until enough material was removed that you can bend up the end plate. after that you should be able to remove the assembly as a whole piece, and discard the rest of the end plate. Dont forget that when you do take that end plate off, there is a detent and spring that will come out, making it 2 million fawking parts that will have fallen out.
The wrench is in two pieces.You can take a flat file and create a back cut on the wrench teeth. This negative angle will pull the wrench to the nut vs pushing it away.