kajuntriton
*Banned*
Three types of FAL upper receivers: Starting at the top is a Type II upper receiver. Type II's ALL have the CHC (Carry Handle Cuts)
The middle is a type III receiver, and lastly the bottom is a type I receiver. Type I and III uppers have the optional CHC's.
There are also 3 type lowers that is a type I and a type II and type III. It is hard to distinguish between the I and II from pics unless you really have a good pic at the correct angle, IN the pic here the Top Rifle is a type II upper and lower as the Bottom is a type I upper and lower, the middle one again is a type III upper BUT hard to tell about the lower.
I will try and explain the difference: If you will notice the type II has the second lightening cut on the very rear lower section of the upper receiver looks like only a very small portion of a circle.
The type I upper has one continuous lightening cut that carries all the way back to the lower receiver.
The type III has NO lightening cuts.
OK On the type I lower the lightening cut has a 90 cut
The type II lower has a radius cut in the lower receiver to match the radius of the upper lightening cut.
Hope this helps without too much confusion!
KT
The middle is a type III receiver, and lastly the bottom is a type I receiver. Type I and III uppers have the optional CHC's.
There are also 3 type lowers that is a type I and a type II and type III. It is hard to distinguish between the I and II from pics unless you really have a good pic at the correct angle, IN the pic here the Top Rifle is a type II upper and lower as the Bottom is a type I upper and lower, the middle one again is a type III upper BUT hard to tell about the lower.
I will try and explain the difference: If you will notice the type II has the second lightening cut on the very rear lower section of the upper receiver looks like only a very small portion of a circle.
The type I upper has one continuous lightening cut that carries all the way back to the lower receiver.
The type III has NO lightening cuts.
OK On the type I lower the lightening cut has a 90 cut
The type II lower has a radius cut in the lower receiver to match the radius of the upper lightening cut.
Hope this helps without too much confusion!
KT
Last edited: