SirIsaacNewton
Well-Known Member
I bought this used. The original owner said that there had only been around 500 rds through the gun. I would have put a lot more but .45acp is so expensive and no where to be found. So I have only put 100 rnds of WWB and 20rds of Hornandy defense rounds through the gun.
So you get the gun the original mag (8 rounder) 5 Kimber-Pro Tac Mags (8 rounders), and 2 Chip McCormick Power 10 mags (10 rounders)
I also have 40 rounds of Hornady 45+P 230 gr XTP to go with the gun as well as 3 (Galco 1919 WC, DM Bullard, and another brand) holsters and 4 snap caps. It comes with the Box, Manual, and Gun Lock
It has an "idiot mark" on it from the previous owner.
I was reading online how to get it out and/or buff it out but I don't own a dremel tool. It is on my to do list. I tried to show it in the picture.
"]
Will take 850.00 cash for it or
- glock 34 and cash
- ar-15 lower parts including:
- good single stage trigger
- ar-15 mag holders
- shotgun shell caddies
- Lower Parts Kit
- Stock
- Buffer Tube kit
- Dremel tool Kit (Since we are on the subject)
So you get the gun the original mag (8 rounder) 5 Kimber-Pro Tac Mags (8 rounders), and 2 Chip McCormick Power 10 mags (10 rounders)
I also have 40 rounds of Hornady 45+P 230 gr XTP to go with the gun as well as 3 (Galco 1919 WC, DM Bullard, and another brand) holsters and 4 snap caps. It comes with the Box, Manual, and Gun Lock
It has an "idiot mark" on it from the previous owner.
I was reading online how to get it out and/or buff it out but I don't own a dremel tool. It is on my to do list. I tried to show it in the picture.
Will take 850.00 cash for it or
- glock 34 and cash
- ar-15 lower parts including:
- good single stage trigger
- ar-15 mag holders
- shotgun shell caddies
- Lower Parts Kit
- Stock
- Buffer Tube kit
- Dremel tool Kit (Since we are on the subject)
Last edited:
