Not sure if this is the correct place for posting this but I couldn't figure out a better place to post.
I may be able to get a sheet of 3/8" AR500 steel to use to make some targets. Any of you that work with metal have a suggestion as to what to use to cut it? Would a plasma cutter be better than a water jet? Not sure if one would degrade the composition and weaken the steel more than the other. Thanks!
I may be able to get a sheet of 3/8" AR500 steel to use to make some targets. Any of you that work with metal have a suggestion as to what to use to cut it? Would a plasma cutter be better than a water jet? Not sure if one would degrade the composition and weaken the steel more than the other. Thanks!