machinedrummer
Well-Known Member
In today’s market which stripped lower would be a best bang for the buck?
In today’s market which stripped lower would be a best bang for the buck?
Sons of Liberty Gun Works
Do they manufacture their own lowers? I might have missed it but there wasn’t a whole lot of info on the mobile site.
Sent from my iPhone using Tapatalk
Well said magdump. Some of the people who buy what many call low end ARs will never shoot enough round through them to even think about wearing them out. Not everyone can afford the ammo to wear out any gun. I would rather have a PSA AR than not have one because i cannot afford a extreme high end rife. Buy what works for you.
20y keyholing from a PSA *just as gud* build. 5.56 7.5in barrel striking the birdcage. Barrel thread was .150 off bore center. Was brought to me to diagnose and fix. Guy didn’t want to spend the $150 to have it cut, crowned and threaded. Replaced birdcage with muzzle protector, or works fine now. He paid me $60 to diagnose it and will pay $60 to swap the barrel when the time comes.
Saw this on Reddit and made me think of this thread https://www.reddit.com/r/guns/comments/gxf4ym/keyholing_so_good_i_saved_the_targets/
learned a ton of good info from watching these. Thanks for posting!
I really enjoy watching the instructor Chad videos. Very informative.
Dave M have you ever considered starting a channel? You seem to be a wealth of knowledge too. We need unbiased reviews and information. I took your advice and ordered a Sionics deluxe LPK and the BCM BCG. SOL was out of stock.
Why would you put glue or epoxy on a barrel nut to hold on a handguard?
How would you get it off if you wanted to change it?
It seems like a bad design choice unless it was just a friction fit and the nuts underneath loosened up and just needed to be tightened again and maybe have some blue Loctite put on them.