Put a new scope on my LR308 and wanted to bore sight it in first.
Directions say to bore sight it in at 25 meters. So I did. But of course I had to play with the laser and noticed if I put the laser out to 100 so yards that the cross hairs were at least a foot low. So my question is adjust it...
**************trade pending **********WTT 5.56 DTI lower / Red X Arms upper. Less than 50 rounds fired. Tight fit bw upper and lower --- zero wiggle.
Looking for semi auto shotgun - have Remington 1187 looking for more reliable. Browning , beretta, benelli. Will add cash for right gun
Other...
Was at Walmart in Baton Rouge. Swung by the gun department and didn't see any of the guns marked down for sale. Guess some walmarts aren't participating in the sale.
JP upper is awesome---- but at $850 is mighty pricey- can build a whole upper for that price.
The White Oak Armament with a 26" barrel would be a lil long for carrying in and out if a deer stand.
Think I might go with. Regular billet BRO upper receiver, Wilson Combat match 6.8 SPC 1-11" twist...
Anyone have experience with these. Looking at Crosshill Tech Ambi - will be used for a 6.8 SPC upper build for deer hunting. Original thought was just to get another BRO billet upper and Diamondhead hand guard to keep the same look.
Thoughts and opinions welcome!
I went ... Agree mostly the same BS as every other show. Did pick up two stripped lower DTI lowers for 99$ piece from Blades & Barrels booth ... Reasonable priced.
Built a new rifle now need some optics, anyone have thoughts on this scope.
Zeiss Conquest 6.5-20x50 Mil Dot - price $699
Will be using for hunting and bench shooting - AR -5.56
Im using a DPMS SASS 5.56 18" barrel. - Not sure if its bigger than 1.15" - Ive always assumed that all barrels would be necked up to the same measurement before the barrel extension.
Emailed PK firearms and they said yes it would fit a low profile .936 gas block, but the barrel nut wouldn't fit a diameter greater than 1.15"
I thought all barrels necked up to the same diameter, but after comparing a DPMS SASS barrel with an extra HBAR barrel I had laying around they don't...
The more times I run the math through my head. I'm starting to think it gonna be to big.
1.31 - .936 = 0.374"
0.374" for the gas tube and set screws seems unlikely.
I know that people with the noveske switch block were having to change them out. Which is bigger than a .750 low profile gas block but not sure how it compares to a .936.
Noveske NSR inside diameter is 1.31".
Cant seem to find an actual height of a .936 low profile gas block thou ...
What is the actual height of a .936 low profile gas block ?
Wondering if a .936 low profile gas block fit into a Noveske NSR 13.5" rail ? The rail's width is 1.48" - assuming the height is close to the same